.. _clicmd_src_vnet_mpls: =============================================================== Mpls cli reference =============================================================== mpls local-label ------------------------------------------------------------------------- .. code-block:: console mpls local-label [add|del] [eos|non-eos] via [next-hop-address] [next-hop-interface] [next-hop-table ] [weight ] [preference ] [udp-encap-id ] [ip4-lookup-in-table ] [ip6-lookup-in-table ] [mpls-lookup-in-table ] [resolve-via-host] [resolve-via-attached] [rx-ip4 ] [out-labels ] Declaration: ``mpls_local_label_command`` `src/vnet/mpls/mpls.c line 370 `_ Implementation: ``vnet_mpls_local_label`` mpls table ------------------------------------------------------------------------- .. code-block:: console mpls table [add|del] This command is used to add or delete MPLS Tables. All Tables must be explicitly added before that can be used, Including the default table. Declaration: ``mpls_table_command`` `src/vnet/mpls/mpls.c line 439 `_ Implementation: ``vnet_mpls_table_cmd`` mpls tunnel ------------------------------------------------------------------------- .. code-block:: console mpls tunnel [multicast] [l2-only] via [next-hop-address] [next-hop-interface] [next-hop-table ] [weight ] [preference ] [udp-encap-id ] [ip4-lookup-in-table ] [ip6-lookup-in-table ] [mpls-lookup-in-table ] [resolve-via-host] [resolve-via-connected] [rx-ip4 ] [out-labels ] This command create a uni-directional MPLS tunnel .. code-block:: console create mpls tunnel create mpls tunnel via 10.0.0.1 GigEthernet0/8/0 out-label 33 out-label 34 Declaration: ``create_mpls_tunnel_command`` `src/vnet/mpls/mpls_tunnel.c line 932 `_ Implementation: ``vnet_create_mpls_tunnel_command_fn`` set interface mpls ------------------------------------------------------------------------- .. code-block:: console Enable/Disable an interface for MPLS forwarding This command enables an interface to accept MPLS packets .. code-block:: console set interface mpls set interface mpls GigEthernet0/8/0 enable Declaration: ``set_interface_ip_table_command`` `src/vnet/mpls/interface.c line 134 `_ Implementation: ``mpls_interface_enable_disable`` show mpls interface ------------------------------------------------------------------------- .. code-block:: console Show MPLS interface forwarding This command displays the MPLS forwarding state of an interface .. code-block:: console show mpls interface set mpls interface GigEthernet0/8/0 Declaration: ``show_mpls_interface_command`` `src/vnet/mpls/interface.c line 203 `_ Implementation: ``show_mpls_interface`` This command to show MPLS tunnels .. code-block:: console sh mpls tunnel 2 [@2] mpls_tunnel2: sw_if_index:5 hw_if_index:5 label-stack: 3, via: index:26 locks:1 proto:ipv4 uPRF-list:26 len:1 itfs:[2, ] index:26 pl-index:26 ipv4 weight=1 attached-nexthop: oper-flags:resolved, 10.0.0.2 loop0 [@0]: ipv4 via 10.0.0.2 loop0: IP4: de:ad:00:00:00:00 -> 00:00:11:aa:bb:cc Declaration: ``show_mpls_tunnel_command`` `src/vnet/mpls/mpls_tunnel.c line 1031 `_ Implementation: ``show_mpls_tunnel_command_fn``