Arp cli reference

set arp proxy

set arp proxy [del] table-ID <table-ID> start <start-address> end <end-addres>

Declaration: set_arp_proxy_command src/vnet/arp/arp_proxy.c line 252

Implementation: set_arp_proxy

set interface proxy-arp

set interface proxy-arp <intfc> [enable|disable]

Enable proxy-arp on an interface. The vpp stack will answer ARP requests for the indicated address range. Multiple proxy-arp ranges may be provisioned.

@note Proxy ARP as a technology is infamous for blackholing traffic. Also, the underlying implementation has not been performance-tuned. Avoid creating an unnecessarily large set of ranges.

To enable proxy arp on a range of addresses, use:

set ip arp proxy -

Append 'del' to delete a range of proxy ARP addresses:

set ip arp proxy - del

You must then specifically enable proxy arp on individual interfaces:

set interface proxy-arp GigabitEthernet0/8/0 enable

To disable proxy arp on an individual interface:

set interface proxy-arp GigabitEthernet0/8/0 disable

Declaration: set_int_proxy_enable_command src/vnet/arp/arp_proxy.c line 245

Implementation: set_int_proxy_arp_command_fn

show arp proxy

show ip arp

Display all the IPv4 ARP proxy entries.

Example of how to display the IPv4 ARP table:

show ip arp

   Time      FIB        IP4       Flags      Ethernet              Interface
   346.3028   0            de:ad:be:ef:ba:be   GigabitEthernet2/0/0
  3077.4271   0       S    de:ad:be:ef:ff:ff   GigabitEthernet2/0/0
  2998.6409   1            de:ad:be:ef:00:01   GigabitEthernet2/0/0
Proxy arps enabled for:
Fib_index 0 -

Declaration: show_ip4_arp_command src/vnet/arp/arp_proxy.c line 434

Implementation: show_ip4_arp